Case stories

NorDan

BrasPine

To BrasPine in Brazil the security of making the right investment was very important as well, as the efficiency and quality of a new line. Therefore System TM installed a small cross-cut line including a MiCROTEC scanner to demonstrate just how much it would be possible for BrasPine to optimize on both their wood and staff resources.

After running the production with cross-cut line for a few weeks, it was obvious to BrasPine that this type of investment was the right solution. Therefore they decided to extend the line with another two cross-cut saws.

Read the entire article on page 7 in TM News.

VTI Vinderup Træindustri

By investing in a window and door frame component line from System TM, VTI Vinderup Træindustri also invested in a new industry trend within window and door manufacturing.

This new trend is to buy frames ready to cross-cut to lengths in the right quality. By doing this, window and door manufacturers are able to utilize today’s technologies without any large investments, when optimizing on their staff and wood resources.

Read the entire article on page 6 in TM News.

Tartak Olczyk

Tartal Olczyk is one of the fastest developing companies in the woodworking industry in Poland.They produce sawn timber, glued boards, square timber and many other pine wood products.

In close co-operation with System TM, Tartak Olczyk decided to invest in a high capacity cross-cut system solution for production of furniture and window components.

Read the entire article on page 2 in TM News.

Rockland Flooring

Rockland Flooring is the second largest producer of laminated trailer flooring in North America. They decided to replace their manual cross-cut line, and invested in an automated cross-cut line.

In close co-operation with System TM, a fast and efficient customized solution was developed which in every way lives up to Rockland Flooring’s expectations.

Read the entire article on page 3 in TM News.